Skip to content

Easton Sonic 6.0 6 Pack Arrows

Save 50% Save 50%
Original price $92.99
Original price $84.99 - Original price $92.99
Original price $92.99
Current price $46.50
$46.50 - $84.99
Current price $46.50
<p>Earn%20[points_amount]%20when%20completing%20this%20purchase.</p>

Not sure which spine? Use our spine calculator, and check your front of center with our FOC calculator.

The Sonic 6.0 is Easton's answer for hunters who want speed without giving up a reduced diameter shaft. At 8.8 grains per inch in the 300, it builds light enough for a flat trajectory across a canyon but still takes a heavy front end if you want to drive FOC up for elk.

This is the older Sonic 6.0 version, not current production. Each pack contains six factory fletched arrows with pre-installed 6mm nocks and six 18 grain 6mm ST inserts. Current production packs ship with 23 grain HP inserts instead, so the component weight is the main difference. Brass break-off inserts and half-outs are sold separately.

Easton builds the Sonic 6.0 in the USA on its seamless Acu-Carbon process, which holds weight and spine consistent from shaft to shaft and dozen to dozen. The factory helical fletch with 2" Bully vanes is what keeps broadheads grouping with field points out of the box.

FEATURES

  • 6mm Reduced Diameter: less surface area for better penetration and less wind drift than a standard shaft
  • Acu-Carbon Construction: seamless 100% carbon process for consistent spine and weight shaft to shaft
  • Factory Helical Fletch: 2" Bully vanes installed with helical offset for broadhead accuracy out of the box
  • Light Build Platform: low GPI leaves room to build a speed setup or load the front end for high FOC
  • ST Inserts Included: six 18 grain 6mm ST inserts for standard 8-32 broadheads and field points
  • Made in the USA: built in Easton's Salt Lake City plant

SPECS

Spine options 300, 340, 600
Shaft weight by spine 8.8 / 7.8 / 5.8 gpi
Outside diameter by spine .286 / .279 / .268 in
Inside diameter .231 in (6mm)
Straightness ± .003”
Stock length 32 in
Fletching 2” Bully vanes, factory helical
Nocks 6mm, pre-installed
Inserts included 6mm ST 8-32, 18 grain
Quantity 6 arrows

VIDEO

If the Install Components box is checked and the Custom Cut Length field is left blank, your shafts will be shipped uncut with factory-included components installed at full length.

Points are added to your cart as a separate item and sized to match these shafts.